Milnor K36 0005R User Manual

Published Manual Number/ECN: H28 0010/2001074N• Publishing System: TPAS• Access date: 2/14/01• Document ECN's: Latest AvailableKit Instruction

ËTensioning Banded BeltsÏ48032BHE, BTG, BTH 48036QHE, QTG, QTBeltDeflect.(inches)Initial Tension (lbs

9

MSSM0303AE/8451BVÈMAIN BEARING AND SEAL REPLACEMENTFOR DIVIDED CYLINDER MACHINESThis section applies to the front and rear cylinder shaft bearings of

MSSM0303AE/8451BV (1 of 5)ÈMAIN BEARING AND SEAL REPLACEMENTFOR DIVIDED CYLINDER MACHINESThis section applies to the front and rear cylinder shaft

inspection plate and use a timber to pry up the cylinder to remove cylinder weight from the bearings. Oncethe bearing is removed, the cylinder drops o

inspection plate and use a timber to pry up the cylinder to remove cylinder weight from the bearings. Oncethe bearing is removed, the cylinder drops o

ÊReplacing the Bearing Housing, Seal Sleeve, and Seals (Front or Rear)1. With the seal sleeve removed, press all old seals out of the bearing housing.

ÊReplacing the Bearing Housing, Seal Sleeve, and Seals (Front or Rear)1. With the seal sleeve removed, press all old seals out of the bearing housing.

ÊMeasuring Unmounted Clearance and Setting Bearing (Front or Rear)The bearings used on Milnor® washer and dye extractors are the very best anti-fricti

ÊMeasuring Unmounted Clearance and Setting Bearing (Front or Rear)The bearings used on Milnor® washer and dye extractors are the very best anti-fricti

Please ReadAbout the Manual Identifying Information on the CoverThe front cover displays pertinent identifying information for this manual. Most impor

ÊTightening Bearing(s) (Front and/or Rear)1. Once both bearings are seated, or if only one bearing was replaced, install the bearing lockwasher(s) and

ÊTightening Bearing(s) (Front and/or Rear)1. Once both bearings are seated, or if only one bearing was replaced, install the bearing lockwasher(s) and

1

MSSM0204AE/8332BV (1 of 1)ÈV-BELT TENSION ADJUSTMENTS FOR 30" AND 36" B-TYPEMACHINES AND 42" Q-TYPE MACHINESThis instruction is to be

MSSM0301AE/9126BVÈV-BELT TENSION ADJUSTMENTSThis instruction is to be used for adjusting the belt tension on the following machine models:A belt tensi

MSSM0301AE/9126BV (1 of 1) ÈV-BELT TENSION ADJUSTMENTSThis instruction is to be used for adjusting the belt tension on the following machine models:A

MSSMA405AE/8737BV ÈV-BELT TENSION ADJUSTMENTSFOR 48", 52", 60" AND 72" WASHER-EXTRACTORSThis instruction is to be used for adju

MSSMA405AE/8737BV (1 of 2)ÈV-BELT TENSION ADJUSTMENTSFOR 48", 52", 60" AND 72" WASHER-EXTRACTORSThis instruction is to be use

ËTensioning Banded BeltsÏ48032BHE, BTG, BTH 48036QHE, QTG, QTBeltDeflect.(inches)Initial Tension (lbs